yeah you can but why not go for arcadetv's his RGB bypass ? Since that uses the VDP signals ?
A arduino sketch for programming the cdce913. Some software for the atmega8 which will be controlling the cdce913. All for a mod i have been...
It kinda look to me like you have way to high brightness or contrast levels set. What kinda of cables are you using ?
Just a few days ago i had the same issue. The main chip had a broken connection. When i pressed on it gently it would boot just fine. Reflowed...
Well i must disagree ;) Your problem might not be the gears but the bowl in the joystick which is torn down. With epoxy and a metal ball you can...
Well there is another solution. You can replace the gears inside the joystick and put some lubricant in there. We have around 35 n64 joysticks...
Which game ? And did you switch without poweroff ?
Have a look at this: http://blog.ampli.fi/nintendo-nes-rf-module-removal/ He did a similar thing to what you want to do.
I am looking for a place to buy the ones that are soldered on the mainboard. I have found a few places where i can buy the piece to put on top. If...
http://www.resistorguide.com/resistor-color-code-calculator/
It wouldn't boot if he hadn't done that. Look at pin 7 of the s-clk. What i did just saw the ppu-1 has rusted pins ?
Well check every point. make sure it won't connect to other lines. If it is the reset switch try disconnecting pin 13. if it boot try soldering it...
Yeah it seems the pads are off ;) But you can still measure the sides of the pads. The pads are connected to a copper trace. The copper should be...
I recon you lifted the pads on the cic ? If so take a multimeter and put it on the start of the trace and start checking continuity to test holes...
Ah cool always good to learn something i didn't know yet.
the big cap should have a marking which uf and voltage. The one marked 102 is 1.5pf no voltage requirement. the rest of the small cap should have...
What happens if you disable the nesrgb board ?
I had two of the 1-chip s-cpu-a which were failing. When i had reflowed/resolder the cpu both were back to working state. Just add enough flux and...
Yeah the optimized games from nintendo/second parties do have some artifacts. I have the same issue with mario world. Starfox is pretty bad as...
Seems like the NTSC mode is only giving issues. Check pin 13 to 8 on the 74hcu04 and the resistors + caps on the 21.477 crystal. The clock signal...
Separate names with a comma.
