I've laid down quite a bit of information and instruction in a thread over at Shmups: http://shmups.system11.org/viewtopic.php?f=6&t=56155 Could...
Interestingly enough, it seems that most of the RF cables for the Playstation have a fully populated connector.
There aren't any compatibility issues with the OG Japanese ROM. There's something in the English translation. A funny write to memory somewhere...
Indeed it is.
I tested this a long, long time ago. Let me guess, this is a 1CHIP board you're testing with, right? It's a DMA issue that effects certain...
Unseen is correct. That's TTL RGB. I failed to see the truth table for color output combinations in the datasheet. [IMG] You have a 3 bit color...
That jungle I/C isn't configured to accept .7vPP analog RGB inputs. It has quite a large swing, let's take a look at the data-sheet. [IMG] I...
Should be a 47uF capacitor there in close proximity to the reset button. Swap it. If the reset cap begins to fail, the system won't properly...
Low active reset. The reset button might not be loading up fast enough. Replace the reset capacitor.
I was doing Dreamcasts with internal IDE to SATA and IDE to SD card interfaces a couple of years ago. There are a few threads around with my work...
You can keep encoded video and resolve the signal coupling (jailbars) in the video, all at the same time. ;) Some 'ole school through-hole love....
Leg 4 is (typically) the drive door latch signal.
I'm a believer in the Matrix PIC fix. As a matter of fact, I came out retirement today to do this very system. It has a horribly worn laser. The...
Correct.
You have to cycle through the various DINO modes in order for music CD's to work, I'm pretty sure the stricter ones break Audio CD playback. You...
Try to stick with Modbo 4.0 v1.93, Modbo 750's gold padded, and Matrix Infintiy v1.93 clones. The Modbo 5 is junk. Probably needs a good reflow,...
Pre 5xxxx series, the only thing you'd typically have to worry about blowing out is the BA chip. The V10 and V12 were totally, 100% booby-trapped..
Multi-Mode will always take a back-seat to the Mayumi V4. Unless it's a PU-7/8 board. lol
No behavior typically means 1 (or a combination) of 3 things: 1: Inadequate 3.3V 2: Poor ground 3: Poor oscillator connection (CX) Check your...
Can you take a few pics of the install?
Separate names with a comma.