Recent Content by VaNDAL

  1. VaNDAL
    Post

    Soda cans with dangerous pressure

    None issue. Get a grip!
    Post by: VaNDAL, Jun 13, 2016 in forum: Off Topic Discussion
  2. VaNDAL
    Post

    Sega saturn netlink matchup

    No you wont!
    Post by: VaNDAL, Jun 9, 2016 in forum: General Gaming
  3. VaNDAL
    Post

    HEX1GON's Supra Diary

    Gold badge = Tacky!
    Post by: VaNDAL, May 17, 2016 in forum: Off Topic Discussion
  4. VaNDAL
    Post

    Sega Game Gear missing solder pad

    Need better pictures. It's basically a case of following the trace, scrape away solder mask and solder (that's solder with a VERY BIG L..soLder)...
    Post by: VaNDAL, May 17, 2016 in forum: Repair, Restoration, Conservation and Preservation
  5. VaNDAL
    Post

    Xbox original prototype

    Ram a screwdriver in that silver sticker and start unscrewing it VERY slowly. Video it and put it on YouTube for us all to see. Do a slow-mo of it...
    Post by: VaNDAL, May 13, 2016 in forum: Rare and Obscure Gaming
  6. VaNDAL
    Post

    What's this Mega Drive mod do?

    He's right! It screamingly obvious what the issue is with that board. The wires a useless at best!
    Post by: VaNDAL, May 12, 2016 in forum: Sega Discussion
  7. VaNDAL
    Post

    Activate 7 controllers with PS3

    A powered D-Link USB 6 port hub. I use when I'm repairing batches of PS3 pads. Usually 50 pads at a time. So I need to have them fully charged and...
    Post by: VaNDAL, May 12, 2016 in forum: Rare and Obscure Gaming
  8. VaNDAL
    Post

    Tony Hawk Pro Skater 2 N64 Alpha prototype

    Fact of the matter is people handle these PCB's like a two year old would hold it's chocolate!
    Post by: VaNDAL, Apr 25, 2016 in forum: Rare and Obscure Gaming
  9. VaNDAL
    Post

    Tony Hawk Pro Skater 2 N64 Alpha prototype

    That's it WHAT EVER YOU DO DON'T hold the PCB by the edges, you have to make sure you get full finger contact over as many bear traces as...
    Post by: VaNDAL, Apr 21, 2016 in forum: Rare and Obscure Gaming
  10. VaNDAL
    Post

    PS1 has a little rust , need some tips for restoring

    I'm not, I'm amused more than anything. It's a PS1 with a bit of rust, toss it buy another or... Turn it in to a project an involve the world on...
    Post by: VaNDAL, Apr 13, 2016 in forum: Repair, Restoration, Conservation and Preservation
  11. VaNDAL
    Post

    PS1 has a little rust , need some tips for restoring

    IT'S A PS1 with a little bit of rust!! Not an AC Cobra restoration project! Dremmel it, Sand it, WD40 it, Etch primer it, Plate it in gold leaf,...
    Post by: VaNDAL, Apr 13, 2016 in forum: Repair, Restoration, Conservation and Preservation
  12. VaNDAL
    Post

    Sega multimega

    Make sure the caps are soldered in the correct polarity! NEVER underestimate how FU*&ing moronic people can be! Always do the non destructive...
    Post by: VaNDAL, Apr 12, 2016 in forum: Repair, Restoration, Conservation and Preservation
  13. VaNDAL
    Post

    Any good REBALL service(s) here on this site? (Devkit)

    Well you can swap GPU from different Xbox but no the CPU. Also while the console is in RROD state the CPU and GPU's are powered on. Try putting...
    Post by: VaNDAL, Jan 15, 2015 in forum: Xbox 360 Development
  14. VaNDAL
    Post

    Any good REBALL service(s) here on this site? (Devkit)

    Well powering it on with out the heat sinks on you have just destroyed the CPU and or GPU!! Sorry but, Well done! That is now an "X" box! The...
    Post by: VaNDAL, Jan 15, 2015 in forum: Xbox 360 Development
  15. VaNDAL
    Post

    PS2 Slim SCPH-70003 Disk not spinning

    It's had the lid off it but other than that it's a virgin.
    Post by: VaNDAL, Jan 13, 2015 in forum: Repair, Restoration, Conservation and Preservation