Recent Content by retrorgb

  1. retrorgb
    Post

    gscartsw: automatic 8:1 SCART-RGB switch

    Yes, that should be correct. SCART cables are directional and since that one says "from" a SCART device (in this case, a Toro) "to" the XRGB...
    Post by: retrorgb, Jul 6, 2016 at 9:28 AM in forum: The ASSEMblergames Marketplace
  2. retrorgb
    Post

    gscartsw: automatic 8:1 SCART-RGB switch

    I've always wanted to try this, but never had time: http://wiibrew.org/wiki/AnyRegion_Changer
    Post by: retrorgb, Jul 2, 2016 at 1:01 PM in forum: The ASSEMblergames Marketplace
  3. retrorgb
    Post

    gscartsw: automatic 8:1 SCART-RGB switch

    Use a Wii RGB SCART cable; It will boot in all red, but you'll still be able to navigate the menus. Then launch USB Loader and force PAL modes....
    Post by: retrorgb, Jul 2, 2016 at 11:56 AM in forum: The ASSEMblergames Marketplace
  4. retrorgb
    Post

    Mapping N64 Overclockability : achieved 3.0x multiplier, but not 3.0x speed

    Has anyone tried this with the UltraHDMI yet? A friend of mine has been wanting to try, but hasn't been able to get an UltraHDMI kit yet.
    Post by: retrorgb, Jul 1, 2016 at 7:19 AM in forum: Nintendo Game Development
  5. retrorgb
    Post

    Is it possible to disable anti-aliasing in N64 games via GameShark cheats?

    Please start that thread...sounds very interesting.
    Post by: retrorgb, Jun 30, 2016 in forum: Nintendo Game Development
  6. retrorgb
    Post

    SNES-Mini RGB Measurements

    Okay, that was it, thanks for your help. I just finished taking a ton of screen captures. I'll eventually try and get an many SNES revisions as...
    Post by: retrorgb, Jun 29, 2016 in forum: Modding and Hacking - Consoles and Electronics
  7. retrorgb
    Post

    gscartsw: automatic 8:1 SCART-RGB switch

    Any VGA cable will work fine. Almost all the ones I've ever seen are wired wrong. Best bet is to buy a VGA cable, cut it in half and make your own.
    Post by: retrorgb, Jun 27, 2016 in forum: The ASSEMblergames Marketplace
  8. retrorgb
    Post

    SNES-Mini RGB Measurements

    Oohhhh....this is all making sense now. It's the exact same procedure as when using the THS7314, since it's essentially doing the same thing...
    Post by: retrorgb, Jun 27, 2016 in forum: Modding and Hacking - Consoles and Electronics
  9. retrorgb
    Post

    SNES-Mini RGB Measurements

    Thanks for the reply! So, first do the basic 3-wire / 75 Ohm resistor mod, then remove R6, R7 & R8 (bottom of the board near the cartridge pins)...
    Post by: retrorgb, Jun 26, 2016 in forum: Modding and Hacking - Consoles and Electronics
  10. retrorgb
    Post

    SNES-Mini RGB Measurements

    I just realized I never updated the 3-wire mod page on my site with the brightness resistors...and it's been so long since we all worked on it,...
    Post by: retrorgb, Jun 25, 2016 in forum: Modding and Hacking - Consoles and Electronics
  11. retrorgb
    Post

    gscartsw: automatic 8:1 SCART-RGB switch

    Just the gscartsw is fine, you won't need anything else. You should be able to. Sorry for the short replies...not being snippy, just really...
    Post by: retrorgb, Jun 21, 2016 in forum: The ASSEMblergames Marketplace
  12. retrorgb
    Post

    gscartsw: automatic 8:1 SCART-RGB switch

    For your PVM, you should buy the 4BNC cable. Your PC CRT will most likely not accept a 15KHz RGB signal and won't be compatible with retro...
    Post by: retrorgb, Jun 13, 2016 in forum: The ASSEMblergames Marketplace
  13. retrorgb
    Post

    gscartsw RGB-SCART project

    Edit: Post in the other thread, not this one. Sorry...
    Post by: retrorgb, Jun 13, 2016 in forum: General Gaming
  14. retrorgb
    Post

    gscartsw: automatic 8:1 SCART-RGB switch

    Yes, RGsB should work fine. Edit: Ha, we responded at the same time!
    Post by: retrorgb, Jun 11, 2016 in forum: The ASSEMblergames Marketplace
  15. retrorgb
    Post

    gscartsw: automatic 8:1 SCART-RGB switch

    LOL, you're missing a LOT: http://www.retrorgb.com/systems.html
    Post by: retrorgb, Jun 9, 2016 in forum: The ASSEMblergames Marketplace