True but I think most console shielding is steel. I've seen rust attack the stuff in old consoles stored outside in sheds. Long ago when I was a...
Your spindle is also broken. That will effect your media reading too. Replacing it with a BAM laser as Bad_Ad84 suggested is a smart move Also...
Totally agree. Seems like a potential overheating issue. Maybe replace it with a Switching Regulator Module. Though they cost much more than the...
Good point. I rarely deal with PAL pS1s around here.
I have seen this issue before. I remember someone suggesting Level 16 adjustment on sync within Framemeister settings.
I don't recall exactly (too many consoles and mods in this head) but is there a specific HEX code/Chip for each region? Did you install the...
Weird. I always recommend taiyo yudens disc for burning. If its reading the cheap media I would be inclined to leave the laser as is. Tweaking...
Honestly if you want the parts I will sell them at cost. AMP,Port & Cable. I do not have a tutorial written for the Famicom but I have some...
Brilliant fix! Will give that a try.
Or maybe the regulator is not making ground. (middle leg)
I repair these for people very often. I notice many new installers forget 3 important steps. Solder jumper J3 & J5. Also make sure GND and Pin 1...
Moral of the Story. It can happen to the best of us.
New I have installed 25+ of these upgrade chips. Today I had a ton of issues with the install. I thought it was a failing laser not reading CDRs,...
All I can say is WOW! I want to see more.
It a fun option and nice for maxing out the DC capabilities. But most games have a lot of lag. Load times are slow and most ISOs need to be...
Separate names with a comma.