Yeah tried taking the Din connector apart and this one went together easier. I have amended the guide to highlight this, thanks Bad_Ad84!
Maybe the one i tried was just being difficult, ill give it a go with the next one. On another note, is there anyway to eradicate the whine on...
I did, but have you actually tried to get the pins to align up again to put the shell back together, i could never get it to go back together once...
So i thought id do a quick guide on modding the Core Grafx system using the EXT Port pins for video and also csync. 1. My Setup..... [IMG] 2....
Hmmm I always find taking the game PCB out of the shell placing it on the edge of a table top and rubbing an eraser across the contacts and then...
Left them in for about 48hrs and didnt change the solution
And another 2 cases done!!!.... [IMG] You can see how yellow they were by the sticker on ther lower PC-Engine, guess ill have to peel that off...
True ill give it a go on one of the pads and see what happens
I added about 7 litres of water and 1.5-2 litres of HP
Yeah the label partially came off, so i just removed it. An ideas on what Hydoperoxide would do to the grey shell of a core grafx?, it didnt seem...
Have managed to scored a few PC-Engines, Core Grafx and Core Grafx II systems, the white PC-Engines were very yellowed so i used some 35% strength...
So you could run a SNES on a PSU as low as 5v then?
Yeah received them this work, installed one and worked a treat. Thanks!!
Separate names with a comma.