Indeed. I liked the PSone screens however the boards are too large for this system. Also of course the screens are rare and very expensive. That...
Thanks.
Was going to make the video today however the weather has been rainy so its been quite overcast. I will make and upload the video tomorrow...
Project is finished, i'll make the video tomorrow or over the next days and upload it when done.
I personally prefer 4:3 aspect screens to widescreens too, although widescreen aren't too bad and yes, these screens have 4:3 option however of...
There is a good chance i'll have this project finished over the weekend; only have shoulder buttons to install and connect, and connect controller...
Yes, could use an arcade stick instead of d-pad however systems with an arcade stick seem to look disproportional as the stick is in the way. For...
Guy i'm doing the commission for (Anthony) is loving the work on the project, which is good to hear! Installed the buttons, here is what it looks...
Installed speakers, installed d-pad, completed almost all the wiring. Working on the controller button section. As you see, the case closes (just)...
Nearly completed the button area on the case, installed the d-pad; need to just do a couple of last layers of paint on the front to remove a few...
Wired up the battery connector packs, external power jack and system. Runs fine off the 7.2v battery packs, tested with one Li-ion battery pack...
Making good progress indeed. Installed the audio amp, connected the game port to the motherboard by the pin headers, secured it in place and...
Battery compartment is installed, similar method to the N64 project. In process of connecting up the game cart, wired up the pins to pin headers...
Each to their own. I compared RGB and composite on a PAL SNES a few years back, thought composite looked if anything slightly better as RGB was a...
The N64, SNES and GameCube are considerably better with composite than many other consoles so the difference to RGB is far less IMO.
Separate names with a comma.